Quick comparison between:

Fisher F11
and
Teknetics Alpha 2000


Use search box below to compare Fisher F11 with something else

Teknetics Alpha 2000
Feature comparison between Fisher F11 and Teknetics Alpha 2000
Options Fisher F11 Teknetics Alpha 2000
Detector Type Coin and Relic Detector Coin and Relic Detector
Price $159 $200
Manufactured in 2016 2010
Battery Type 9V 9V
Weight (Lbs.) 2.3 2.2
Operating frequency 7.69 kHz 7.8 kHz.
Display Yes Yes
Backlight No
Target ID 9 segment Numeric
Tone ID 4 Tones 3 Tones
Search Modes
  • Jewelry
  • Coin
  • Artifact
  • Pinpoint
  • Discriminate
  • Motion All Metal
  • Pinpoint
Ability to change coils Yes
Ground balance Factory preset Auto Preset
Waterproof Coil only Coil only
Warranty 5 Year Limited Warranty 5 Years
Number of Reviews graph 1
graph 2
graph 1
graph 1
Avg. User Rating 3.00 4.25
Avg. Durability Rating 3.00 4.50
Avg. Ease of Use Rating 5.00 5.00
Avg. Depth Rating
Depth value
Depth value

Most helpful review for Fisher F11

Fisher f11
In the beginning about 15 years ago I use the cheapest metaldetector (wellerman or something like that) from the supermarket and never find anything, maybe a few coins. But about 3 months ago I buy my first little more better and was satisfied what this fisher f11 can do. My findings with this cheap beginners metaldetector was coins, copper, silver juwelery but only one gold necklace but I was happy into the soul with my findings. Yes its average beginners metaldegector for cheap money and if you want to try the hobby don't buy the most expensive machine you can dig and find really good stuff with this Fisher F11.

My deepest finding was a copper coin from 1861 on the beach from 10 inches.
Kristian from Sweden

Thumbs up! 8
Read all reviews for Fisher F11

Most helpful review for Teknetics Alpha 2000

Teknetics Alpha review
Took the Alpha to an old ball field for a few hours. The site was on a slope were the old bleachers had been tore down. Iron was everywhere. Important to note, that is why I chose to run the discrimination wide open. If the detector can id iron then there is less chance of masking or iron sounding like a good target.

The detector ran very smooth at full sensitivity with no chatter. I tested the EMI issue under power lines and the field light transformers and no problems at all. Honestly I was very surprised. Early on the Alpha had problems with EMI. But Teknetics fixed this with heavier coil cable. The "56" nickle I doug was actualy showing 5c on the display. 4-5 inches down in the red clay here. I was spot on with the pinpointing also. As I am use to Tesoro's I just X'ed the spot. Although nothing earth shattering was found by me I feel this detector is worth more than it's price. No ron, none no nails or can slaw. And trust me it was everywhere. It likes pulltabs. That is a good thing to me because it will like gold too.

The dime I found was proof that leaving the disc. open helps find good things in iron. I got the low tone before and after the small high tone. I thought I better slow down my swing and listen. Sure enough I could here a hight tone between the two low tones. So I dug and out popped a clad dime. Now I'm impressed. Depth is not an issue either. The last target I dug was a memorial at 7" next to the side walk. Are their any bad things with this detector? Not realy, for 200.00 it can't be beat IMHO. The stock 8" coil is ok but I am getting a 5x10 DD to realy enhance this detector. HH
Jim D. from North Georgia

Thumbs up! 69
Read all reviews for Teknetics Alpha 2000